Search:

A good fasteners store should
have a thread gauge so you
can get the right die or thread
file.

Can you use a thread file to re-store the thread, they cost around $35 for memory
but a handy bit of kit. even a set of needle files may help in restoring the thread.
Worth a try imo

http://www.nissanpatrol.com.au/forums/images/imported/2015/05/242.jpghttp://www.nissanpatrol.com.au/forums/images/imported/2015/05/243.jpg

Sorry. This is how I got it.

http://www.4x4australia.com.au/drive/1504/bent-utes/

They also have a small nyon ‘restrictor’ to fit inside the tube - part no 10027 - see pic. Not sure if it would cause the issue you have if missing, but does apparently stop the needle from being too...

If it has a brass olive you place on the tubing before the nut ,
then you will need to nip it up so it squashes slightly

I would suggest that it should not be sucking any air. Could be wrong though.

Sent from my iPhone using Forum Runner

Saw this on faceache. Thought I'd share it.

Sorry I have attempted few times to embed just the video but it's a no go. Sorry to those without faceache.

...

Just in case you don't know how to use an anvil.

Took it out to harvey area and Brunswick was a good day out

@ Timbo15 check the "what I did to my Patrol" thread A member
just fitted his light bar to his roof rack, well protected spot too

Stuck a light bar on the roof rack

Gutter mount - I am guessing you mean for a full width bar not 2 small ones either side.
None around that I know of and given the need to support most of the bigger bars in the middle and ease of...

I originally mounted my 240 watt light bar to a single Rhino rack with a bracket I made from some 40x4mm flat.
ATM i made a purpose built roof rack with bar brackets incorperated.
That will change...

Aurora are the best out of the cheaper Chinese bars. If you want a brand then Great whites are really good. I have seen these in action and are good. But having said that, I have a cheap chinese...