Search:

This issue is very common on series 4.

There are 2 pressure switches and a resistor. Nissan's fix is to replace all of them 2x senders @$35 each and $139 resistor. Faulty batch of switches, they...

I take it your egt reading is in Celsius? If so thats right on the top end. Even way too past for my liking.
Using a needle valve will enable you to control spool up and therefore reduce your...

Had a few people ask about this mod since i have done it and also why i did it in the first place.
I have added a lift pump (fuel pump) into the line of my ZD30, therefor keeping a constant supply...

Too easy mate. I sat there for ages on Saturday arvo thinking how I could do it. BA came over and had a look, then left. I cracked another stubbie, asked on here, had a scotch, then the light bulb...

Gimmie a bit bud. I wanna photo chop the pics so they are easier to understand....
But the original steel bracket that holds the rear of the old tank needs to come out. As I used this bolt hole as a...

some here run 30psi mine is about 28psi Mullet hunter has 26psi all with no problems.
Increase your boost a little at a time and see what happens, Disconnect the battery too, to erase
any memory,...

The Coleman hot water service is an awesome piece of camping equipment, it allows you to have a shower anywhere when you are out camping.

However the only issue (that I have found) with the unit...

Not sure tbh. But I assume it will.

Heres the pics of mine....

The allen key bolts on the bottom edges are just on angle iron braces I welded on for protection, as the tank hangs down lower. I will make up a bash plate also I think,...

Have a read of this mate and have a look around there. The basic instructions will be the same for the rear replacement and the sub replacement.
...

I have 2.5" lift (closer too 3"), 33's, roofrack, drawes, winch ect..
I Have a Voltage Modifier on my MAF in my troll so I run 9 psi roughly at 100km/h, EGT'S around 320 degrees.
Max boost at 20psi...

I just came across this on another forum and had not seen it before and thought guys would be very interested in this..


BOSS-Chassis-Coil-Tower-Brace-Kit-Nissan-Patrol-GQ-GU-Y61-Bolt-In-DIY-Kit...

This was shared with me and it's quite funny. If you're sensitive maybe don't watch it haha.


http://youtu.be/eyobTarVvgE

They are a full aftermarket Zylux 7" system. Cost about $500 about 2 years ago. Good enough for the kids.

Hi mate. I think mines not any worse than it was before. I haven't noticed any leaking for a few weeks now. Sometimes I can smell the coolant although cannot see anything from that area. I'm still...