Search:

I'm not 100% sure how they come off either, but you can buy replacement hinges so it's possible somehow. My guess is it's mounted internally and requires the door trims to come off to access the...

My guess would be that the hinges are slightly bent due to once having a large spare wheel. Are your old door hinges still good?

remove a FWH's both sides and see if any water has been sucked past the seals ,
hot diffs and cold water not a good combo

Very nice and tidy, and simple too! If I get lucky enough to add a SWB to my garage soon, I will be doing something very similar to this!!

-Piet

Thank you for the write up. I have to do something myself to go behind the third row seats.

I'd say penny washers /mudguard washers would be perfect, great write up Btw thanks for sharing

Stop opening your bonnet so much and it wont wear out as fast.
must be a GQ thing lol

I bought exactly that and the clip the holds the rod off eBay, infact a quick search and I found one......

If all you are doing with the compressor is airing up then there is no need for a tank. If you want to fit air lockers down the track though the tank will be a winner for that. A Tank will also...

I see now you have closed off the system , so it holds pressure in the lines.
I would be fitting a small tank underneath, to run locker if needed, air horns ,etc
But your system will work now you...

You can use rubber door stops to cover the outlet from getting full of shite

Heaps of different sizes, take a sample to a bearing place ,they should sell them
or buy a grab kit off Ebay

yes definitely have different sizes also if you have to install them yourself you will probably need to knock them in no thread on the nipples

So you got it all sorted now ?

Sometimes the foam that is used to seal the flaps, will fall to bits over time ,and can jamb the flaps, a airblower blasted up the feet vent holes while working the...

Yes Lithium spray grease is good.

Normally on the side of the chamber, if you can look up under the dash area using a torch, and see where the cable attaches to the slides, remove the cable off...