Search:

Look under your bonnet you will find your vin number stamped on an alloy plate. On this plate it says trans/axle and there will be a some letters and a couple of numbers. I can't remember exactly...

An entire diff center will be the way to go.

But I'd still tighten the pinion nut, drain the diff oil and look out for metallic particles as well as feel inside the drain hole for any large...

Colapsed pinion bearing or loose pinion nut, either way, she's cactus.
A new diff centre and you'll be off like a dirty shirt!!.
Cheers, the ferret.

Criest! Never seen that before. You might get lucky by pulling off the tail shaft at the diff end and adjusting the pinion nut(ie just tighten it up to remove the clearance) though that's a long...

I'm planning to add a reversing camera but I don't reckon I'm going to hook it up to be activated when in reverse. I intend to just have it switched so I can turn it on any time.


Tip tip...

Give patrolapart a call they will sort you out.
Address:
424 Maroondah Highway
Lilydale, VIC 3140
(100 metres East of Lilydale McDonald's)

Phone: (03) 9735 9099
Fax: (03) 9735...