28th February 2018, 06:58 PM
G’day DT mate! Be careful listening to MudRunnerTD, he’ll turn your truck full comp worthy for sure:-)
Still take a little loved one/s out and about sometimes in the ute and dogs also love to jump...
10th January 2017, 07:34 PM
I had no issues when fitting a 3" system to my 2009 Crd. Just had the car on stands, so the front wheels were just off the ground. I'm sure I didn't have to get anything out of the way. The big bitch...
10th January 2017, 06:46 PM
No need to lift the car up mate, however if yours is ZD30 powered then the OEM dump pipe/DOC (Diesel Oxidation Catalyst) will not come off unless you drop LH side of the sway bar (front).
Regards
24th December 2016, 08:47 AM
So in heading away for Christmas and as part of my pre-trip check I tightened my front wheel bearings. While I was at it I thought I'd take some pics and show how easy it is.
So I have jacked the...
15th September 2016, 08:54 AM
You can get them for that price haha, if we are talking about the bearing behind the clutch then its an easy job all you need is a puller and a press make its easier. or a good hammer. Use the puller...
12th September 2016, 09:45 PM
The a/c bearing can be replaced.
I did mine about a year ago. Plenty of info on the web on how to change, not too hard of a job.
Best is to take off the belt and spin the a/c by hand, if noisy...
3rd November 2014, 07:22 PM
You can buy on ebay a complete set up and wired to turn off DRL`s when the, either parkers or headlamps are switched on.
I have done this and it works a treat.
I can`t help you with a link but...
1st November 2014, 12:26 PM
It is a weird rule like a lot of others but, Yes, aftermarket DRL's must turn off when headlights are on whilst Factory fitted don't (altho most do).
I wouldn't bother with a relay for load as the...
1st November 2014, 11:07 AM
You could wire them to your parkers and have a toggle switch on the earth wire,
to turn them off when your headlights are on, The toggle could have a LED in the
end of the lever
