Search:

Ontrack 4x4 Fabrications in Neerabup. Pretty sure they do or have done engine conversions.

Like Ive said a few times which may suit your needs I use a Icom 400 or something like that with a remote handpiece,
I ordered a RJ55 patch cord so I could fit the mike nearer the passenger side, By...

We've got a 2002 grenade and have replaced tensioner twice but never noticed a voltage drop, replaced alternator because the clutch was seizing up , I was told the wires to alternator do get dickie .

Yes, that is OK

13.8 at idle is the minimum anything below that is bad.
14.2 at high idle and above is OK

Wow! You spent so much trying to find the issue and it was the chip?! Wonder what Dtronic would have to say about it...

Heres a list of the codes....
0087 Fuel Rail System (Pressure too low)...

Depends on how much off roading its done.

Really would GU body mounts be flogged out already
Long time between posts Fenda lol

Check that the lhf panhard rod nut is done up super tight. I had a similar clunk which went away after loosening and retightening the panhard nut.

The 1st row body mounts are about 40mm in height new, 2nd row body mounts are about 45mm in height new, the 3rd and 4th row mounts are about 48mm in height new. Check this against yours.

also maybe check the shocks rubber bushes if you cant find anything else

With modern electronics they should both read the same especially as they are both getting their signal from the ECU.
The gauge would be the most likely to be incorrect, probably something on its...

Or body mounts.... but not n this case lol

Like i said.... nearly always radius arms.

have you checked the CVs


Sent from my iPhone using Tapatalk

Grab some weld on washers from threedogs.
You'll need 8 and 4 new m16 grade 8.8 bolts 110mm long preferably in a metric fine thread..
Remove bolt, insert a washer either side, tighten and the weld...