Search:

Hi Ronnie

PM sent

Chimo

I had the same wobble at around 80 to 90kms when I bought the gu a few months ago and thru research on this forum systematically started looking at things to change but thought I would start with...

This probably has been checked but this solved my wobble issues for good. Even when running 35s.
where the inner wheel bearing sits on the stub axle it had worn away at the section where the seal...

Turns out there might be a few more fundamental problems with the beast. Lots of stuff to consider, replace and maintain. Whilst the wobbles remain abated there are additional underlying issues that...

I hate the shoit!.... lol
As for my Patrol this is what i did to remove the wobbles which i had a bugger of a time. Tighten my wheel bearings. Whilst the wheels felt good on the stands only just the...

must take top and bottom out for even pressure.
10,000k since i took mine out, and not a hint of the return of the death wobbles....

When taking shims out, aren't you supposed to remove from top and bottom?

Pull a shim from the king pin side, top and bottom, one each side and re tighten. See if that fixes the issue..
If it does then bearings need doing but just remeber where the shims go for when you...

Lots of information on this on here. Unfortunately it could be may things..
A few little tricks to try.
Tighten wheel bearings and.go for a spin..
if no good try greasing each rod one by one and...

That's up to you me personally I wouldn't it wont need it just remove the shims, oh and have you noticed over 1700 hits to this thread wow lots of views

I sent you a PM

Ok cheers, you'll be amazed with the handling once its done.

Yep - new coils and shocks. They are possibly talking an adjustable drag link but if you are going standard or up to 2" (50)mm lift you don't need it. Sometimes if your suspension is worn out, just...

Good to hear, I like the tighter steering too just feels better cheers mate. I wonder how Rhonda is doing with her car?

mine has decided to start this crap - well so far over the last 6mths I've completely replaced all bearings, inc king pins - slightly tighter pre-load than spec on everything to stop mine - as well...