Search:

Done this today!

https://uploads.tapatalk-cdn.com/20240920/153c5c61cd2560be6e6010b096d3a05d.jpg
We in pretty much in the middle
Of nowhere with no mobile service. A balmy 30c outside, on our way...

Page EC-11 shows that power supply to the glow plug relay comes from a fusible link. The control for the relay goes to pin 111 on the Engine Control Module.

Page EL-269 Shows the fusible links...

I have had Optima Yellows go to Zero and have been able to pull them back up to charge. They are a very hardy battery.

Its great when issue appear just before a trip! Not. While my trip is not a epic as yours i'm having a few issues also. But now, all my work has to be done outside and in the dark and i can't get the...

Out with the old light bar….
https://uploads.tapatalk-cdn.com/20240914/1311b55c8e7a0e1efdac71ad0d6e1f2e.jpg

In with the new....

Definitely 60 degree taper on the Y61 17" factory alloys, and the handbook for my 2015 GU Y61 wagon states 97 ft/lbs tension. I do a recheck after a few hundred ks, and also re-do the tension anytime...

Roger that. The only reason I stressed the point is my GU2 alloys had flat seats. Must have changed somewhere in between! All good.

ROH Trak 2 Steelies are the best in my opinion Phil. I've seen pics of the cheaper Chyna made steelies literally falling apart.

Genuine Nissan GU steelies. You’ll find them cheap 2nd hand online.

88313

Mate, personally I would change over to steelies, but that’s just my preference. Pros and cons for each. Steelies = higher unsprung weight but more malleable and forgiving when out the back of...

Yep. Good for GQ owners. Us GU owners either have to run the gauntlet with illegal HIDs or LEDs, or stick with candles.


Sent from my iPhone using Tapatalk

Jeez Phil, super glad you got out of that relatively lightly.

What seat-type nuts are you using on the alloys? Use the tapered nuts on steel rims, and flat seat nuts on the alloys.

100 ft/lb...

This is the way I was taught when I got my first car:
After the wheels have been off, always mount the rim on the studs and start the nuts manually.
If using a rattle gun, only use it to do the...

Maybe fill the cans and do a test run Phil before venturing off? Just to be sure.

Put some new H4’s in. Hopefully better than the candles I had burning before.
https://uploads.tapatalk-cdn.com/20240910/33a9791ba5368591b948a3b5decad15e.jpg


Sent from my iPhone using Tapatalk