Second layer was (I think) open cell foam.
88350
88351
88352
88353
Second layer was (I think) open cell foam.
88350
88351
88352
88353
I have sound deadening almost finished now. I have covered the whole floor pan covered with 3 layers of different products, except for the trunk, where different products (yet to be acquired) will be...
In 1985, a Nissan engineer was designing the upcoming Y60 series. He realises the difficulty that mechanics will have accessing that bolt in the future. He draws that particular hole in the plans,...
Not exactly today, but last weekend.
Nothing beats a saturday arvo working on the GQ having a cold beer, right? But wait! What if this time it was on my new stubby holder? Courtesy of legends...
OK, another day in the garage, new BFG HD Terrains on, painted both surfaces of the aluminum hub and wheels to arrest the corrosion - Willwood hubs are a higher grade of aluminum than the nissan...
Just a nice relaxing weekend...
This is my 2005 Patrol, my father bought it in 2004 and it's been in the family ever since.
I want to start off-roading, however I know very little about what to do first.
It's got a ZD30 with...
Will take some next week when home, in Singapore for GP atm.
Page EC-11 shows that power supply to the glow plug relay comes from a fusible link. The control for the relay goes to pin 111 on the Engine Control Module.
Page EL-269 Shows the fusible links...
Yep, they do.
Yes, it does remove ads. You also get access to YouTube music, which is a good bonus.
Although I just cancelled our family plan at the start of the year as they put the cost up from $22.99/month to...
We got rid of all our streaming video services. But we do sub to Youtube. We watch that nearly every night now, once you start looking at different things, YT starts sending you more related stuff....
So I have more room.. Theres is not a lot of room in the back of the wagon plus cooking out the back of it with the barn doors open is a pain in the ass. A properly decked out pod, that is dust...
OK, decided to swap all the studs out on the basis they were all installed by the same method that resulted in the first wheel failure. Started at 8am, finished at 4pm, nice and easy, just...
OK, I found a source that gives a seating torque from a rattle gun at 210nm for an M12 x 1.25P wheel stud. I have trawled thru my text books and found the method to calculate the torque, finally,...