Qwik piks of the air install on mine.
Runs off the A/C pulley (obviously)
Only issue is that it is goddam hot down there under the A/C
Soooo... I'm thinking of sourcing cooler air somehow
Qwik piks of the air install on mine.
Runs off the A/C pulley (obviously)
Only issue is that it is goddam hot down there under the A/C
Soooo... I'm thinking of sourcing cooler air somehow
Have removed now the stock PS coolers and stock lines that were in my way for new oil coolers. http://www.nissanpatrol.com.au/forums/images/imported/2017/11/36.jpg The new Davies Craig Hydro Cool for...
Kindly received some pics today from http://www.blitsbodykits.com.au/ for the GU Supercharger bonnets if anyone needs raised rainsey Cheers mate!
I believe this one below is for GU4 and onwards:...
much prefer this one with built in intercooler.
73312
Some of those P400 pics are screaming "supercharger bolts on here" to me...
All done mate...
http://nissanpatrol.com.au/9-2815-237-34.pdf
Here are some more pics. the last one shows the bed plate of the P400.
731977319873199
Believe it or not, this is a P400
And I specifically said, no vac pump too......
73195
73196
Hmm, I spoke to Greg on Wednesday and talking about my heating issues and he indicated that he was removing the viscous coupling from many vehicles as he had a machined adapter that brought the fan...
Hi Mark I have spoken to Scottie at BD and explained the temps I have experienced - he said BD are getting some "new" viscous fan hubs - apparently lock up better to provide more air flow. Waiting...
G'day Phil, I'm by no means an expert on these donks sorry mate, just learning my way through them too to make mine hopefully bulletproof. Here is the page photo again from the US military full...
Good little article here for you guys with overheating issues before you chop your cars up
http://www.autospeed.com/cms/article.html?&title=Undertrays-Spoilers-Bonnet-Vents-Part-1&A=113176
I used 45 deg and stright hoses and pipe in between I have had the 4" snorkel from the start so can't comment on any performance gains
Kimbo, how did you get them 'pre-moulded'? By that I am assuming they were moulded with the bends/changes or directions?
Have you had the 4" Millweld snorkle since new or changed from a plastic...
Sorry 131-103 :-(