Mateee! Some bad luck there Mark. But lucky you're all good. Is this your rear/driving tyre??
Could this have been tire spinning on the rim????
Didn't know such things existed until I seen it my...
Mateee! Some bad luck there Mark. But lucky you're all good. Is this your rear/driving tyre??
Could this have been tire spinning on the rim????
Didn't know such things existed until I seen it my...
Glad it burst while you were stopped and no-one got hurt. That could have been so much worse. Enjoy the rest of the trip.
That's all the bad luck for you mate.
Enjoy the rest of the trip. Brilliant part of the world your heading to..
Sent from my Pixel 7 using Tapatalk
Geez, that is a run of bad luck mudski!
How many K's had you done on those tyres in 7 years?
Its big enough. all miles, have a safe and trouble-free trip
Wiring issues again. FI Interchiller has been under performing, not chilling adequately, so went chasing the switch valve, found it down on volts so am going to upgrade the line size, however plugged...
Couple of comments. If you do this make sure its a body on job, body off is a mass of complication and heartache. Also the can will be heavier as you have to factor in the frame of the tray, tray...
I agree Marko you’ve got an awesome GU TD42 wagon plus fantastic accessories. But I’m going to be devil’s advocate and ask why you want to chop the back off? Any GU wagon can be a touring legend....
Looking good Markie, Phils is a CAM Fabrications kit with an at home install then engineered. . I know DMW do chops in Queensland along with GVM upgrades and chassis extension aswell, not sure who...
Definitely 60 degree taper on the Y61 17" factory alloys, and the handbook for my 2015 GU Y61 wagon states 97 ft/lbs tension. I do a recheck after a few hundred ks, and also re-do the tension anytime...
Spoke with PAP this morning about stud strength options and applicable nuts.
The factory studs are the go, however their aftermarket studs are 'marketed' as being stronger and cheaper than the...
Genuine Nissan GU steelies. You’ll find them cheap 2nd hand online.
88313
I bought 3 packs of 5 from 3 vendors, first set arrived today, have a few spares now, fitted them this arvo, good quality fit and nice and fat for a good seal.
Gottcha, yes the HID are not approved globes full stop, but the 7" round inserts are. PLOD may try to disagree but they are stamped on the light and VASS approved.
88294
88295