Search:

He made two visits Robo. Second visit he put duct tape over his plates. You don't do that if it's stolen. He owns it.

Distinctive. It's been seen by others around Werribee. LED light bar is held...

Werribee Clay Target Club would like to get their stolen equipment back, and have a chat about damage to other equipment. Which I'm guessing means Werribee police would like a chat too...

People...

Hi All,

Anyone recognise this fairly distinctive Patrol? The black bonnet & rod holders make it reasonably unique. Trying to work out what that rego says is a bit of a challenge from this pic but...

4.2 pumps aren't electronic. Just the black box that controls whether to power the fuel shut off solenoid.

Unless you're installing the ignition to detect the right key & all the other NATS stuff...

There's a procedure in the manual for over riding the NATS system. I'd give page numbers but it probably varies from model to model.

Basically it involves turning the ignition off for a minute,...

In May this year up in the high country I stopped for a lunch break and when I went to move the truck (GU Series 3 4.2 Turbo Diesel) forward to level ground it wouldn't start. Bit odd I thought, and...

Hi Dave (1),

Third try at this. I'm at work and the pager keeps going off.

I've knocked up some drawings that should help you out.

If you have any questions feel free to ask. These will work...

You can put in a dynamco for half the cost of a genuine fob & get two remotes though. Just involves a little more work.

Might mean you only need the controller if you already have an actuator in...

I'd be suggesting that normally the pin should be positive & the housing grounded, so with the multimeter red lead on the pin in the middle of the bulb receptacle and the black lead to the housing...

Hi all,

Disregard the previous post asking for a pin out for the central locking control module. It's gone.

I was a bit sick of the short range of the factory remote, and I'd drowned one and...