Search:

I finally fit a 3 inch exaust to my patrol and put a K&N air filter in and went to United fuel Injection for a Tune to which they installed a manual boost controller and they welded the intake...

Hey Boke just a thought i used to run the original aluminium radiator and i filled it with mud one day out the bush and i thought i cleaned it all out but i obviously didn't do a good enough job and...

Hey guys regarding the removal and intstallation i will be building a frame and removing the centre console and lowing to the ground with a chain block

Regarding the cost for the 4terrain clutch...

Just a pic i took the other day down white hills beach it was such a nice arvo

Hey mate you got any pics of what your doing be good to see

Hey guys just thought you might be interested in this one

My pops front end of his nissan patrol got hit by a bus and cause his insurance run out and didnt put it back on again i have to fix it....

i made the section up myself the gear i just bought from a industrial painting place but if i was going to put a tank in i would get stainless braided lines made up for me

Hey mate could it be your torqe converter i know that these can be a real pain in the A#$E when they start playing up also maybe your clutch plates are not letting go Just a thought

Also your...

Hey Mate check my thread out its a really easy job you should be able to finish it in a day

I have photos and some dimensions of the brackets there also if you havent already done it yet and i...

Guys if you would like any more info just ask and i can let you know

Hope this is a help for anyone going to tackle this job

Installation of Seats and Trims


For the installation of the Trims and seats i got a phillips screwdriver and found the holes and then i cut around the holes with a stanley knife so there is no...

Now for the Compressor

The compressor is the largest in ARB's Range

First of all i purchased some 40 x 40 x 3ea

I then cut 4 sections @ 100mm marked out a centerline on the 4 angle...

Sorry for the delay guys but hear is the finish of the carpet and compressor installation


For the front section of the carpet it needs to be cut in half ( Photo 1 )

Once cut in half you then...

Mate id go with the degreaser option sorry man but i have to lmao done this to a gravel drive way before you can get enviromentally friendly degreaser maybe that wont kill the lawn so much otherwise...

Well guys when i removed the back section of carpet i found a substancial amount of engine oil under the carpet and as i found out they knoced over engine oil in the back so i had to do a bit of a...