Search:

There is no drilling or any special tools. All you need is your socket set, 13mm and blue loctite if you like and maybe longer bolts. Using the existing mounting points for the bonnet hinges. ...

hi PeeBee, the compressed length is 215mm when closed it sits just below horizontal following the quarter panel line. hope it helps. Here's a front on. 75952

If it is a one off about $150- approx. Haven't worked out postage and handling yet. Posted an image75948

hi all, I did the test in 2wd along a quite industrial park. It does get hot when I stomped on the brakes quite a number of times. Will conduct the test in 2wd (hubs engaged but transfer case not...

no, I have noticed it even on normal roads, say when there are lots of stops and starts (particularly this time of year). Mine a a manual td42 y60.

anyway, I have just bled the bpv. the initial...

dom14...you were correct to note that the gap was due to the lift with no bracket to compensate for it. Made the bracket, put it all back together and yup.....no gap. please find attached photos to...

thanks....will look at making a bracket today. shouldn't be too difficult. will post a picture when done.

here is a picture of the rear brake proportioning valve...pls let me know what you think. many thanks again74014