Hi Dreamer. Welcome. There are always people doing the tracks down there. It's my backyard lol. Hit me up when you are going
Hi Dreamer. Welcome. There are always people doing the tracks down there. It's my backyard lol. Hit me up when you are going
I doubt you'll get an answer till you head over to the introduction section and formally introduce yourself but Welcome to the forum.
Taslucas the Church Rock track was closed and the main track from Interview River to the Pieman plus the inland track from the Interview mines to the Pieman River. Yeah lots of small tracks were...
They don't seem to blow head gaskets very often. More likely to crack the head unfortunately than blow the gasket as I've found out .
Whilst fitting the standard tyre/rim on the troll today to be organised for the new 33's to be put on the standard 17 inch rims I decided to have a play in the paddock with a set of tyres and rims...
New Mickey Thompson 305/65/17's and a set of Vibe 6.5 inch speakers for the rear doors :)
From Burnie in Tassie I believe
You'll know if you are in limp mode. No power !!!
I haven't blocked my egr yet as I'm waiting for a mod plate inspection from the transport dept and it won't pass with egr blocked. So with egr blocked plus diode , voltages should be back to nearly...
Ok I just tested the diode theory. No limp mode at 20 psi. BUT very sluggish engine. I'm guessing with the lower maf voltage through the rev range the ecu is not allowing the required fuel needed.
The brother has had one of those for a couple of years now. Got him out of a fairly bad situation a couple of months ago. I was impressed enough that I now also have one. Bit slower maybe than a...
Sounds like a head gasket to me.....
Might be able to help out with some guiding in my backyard - NW Tassie, Arthur River, Sandy Cape, Balfour etc.
This is my best friend "Maya" . Bred from a pure Boxer and a pure Huntaway. Very energetic dog !!4268742688
Bought a Scotts Rods 3 inch exhaust today :D