Hey Ab, finally sourced all the parts and did my own snorkel, hard a few issues at the beginning in regards to the nutserts as I had never used them before. I have a few recommendations, If you use...
Hey Ab, finally sourced all the parts and did my own snorkel, hard a few issues at the beginning in regards to the nutserts as I had never used them before. I have a few recommendations, If you use...
thrust bearing, replace it and get a new clutch while you have it open
Heres a manual if anyone has one of these, I bought a GQ with this CB in it without a manual and I would like to share it with you, hope it helps if anyone would like some info as they have quite a...
So after browsing this forum as so many of us do, I saw a thread where someone had made a rear draw system using no ball bearings or runners and thought it might be a bit sloppy but could work if you...
Well anyonw who reads this might like to know if they have the same problem. I had to replace the clutch booster as the diaphram had a hole in it and wasnt holding any vacuum.
Cost me $50 from...