Search:

Look up Magnum flexplates. They do a heavy duty item for the T engine with the bigger PCD.

Edit: Should have written that Magnum can make a standard flexplate for the non-T engine which is what...

I've had my pan off quite a few times since I've owned my Patrol and I've never seen any reason to replace the bolts and I've never had issues with leaks.
I don't understand what they mean by...

The high idle can happen when someone plays with the fuel screw. You can't back off the throttle lever enough to compensate for the higher idle.

I use the OEX universal glow plug timer. I see they're around the $150 mark now. Converting from TB45 to TD42 meant no existing glow plug circuit so this was best option at the time.
It's been...

#1 It will be accurate for 3 cylinders. Put it in the dump pipe like 99% of people do.
#2 You can eliminate the inlet manifold boost valve if you know your wastegate system is functioning correctly...

Climb underneath and look at your bellhousing. I sent you pics in our other conversation that clearly show the ribbed bellhousing that the RE4R03A has. If you have the smooth bellhousing it's a...

Not bad for an 80 year old eh?

Couple of misconceptions I read there about the induction plate, they're not big, heavy nor expensive. Mine is 280 x 300, I can pick it up with 2 fingers and it cost $49.95 at Aldi. My air fryer cost...

I’d seen some good capacity testing and general reviews on YT so decided to take the risk. If it breaks down and they don’t want to know about it in their 36 month warranty period, I’ll just take it...

When I had my 2001 Ti GVM upgrade to 3550 kg done in 2018 here in QLD, the requirements were that the vehicle had to be diesel and had to have ABS. Mine is converted to TD42T from a TB45E but...

Not sure if this is the kind of thing you’re wanting but I run an Aeroflow pump with my W2A system. Has 1” barbs but there is a model with 3/4”. It’s rated at 46.6 l/min but no idea if it really does...

There is no dash on/off switch needed because that design is based on the system cutting out when the brakes are applied.
The disadvantage of that system is that it cuts out the lockup every time...

Make one from a copper tube with the ends crushed to suit

I'm still happy with mine, works well once the ECB pads have warmed up. I've also now fitted a VF Commodore UP28 electric vacuum pump for the factory diff lock so I can get rid of the vacuum pump on...

A common issue with the small induction plates is that the lower wattage setting is often obtained by pulsing the higher wattage. I tried to avoid this by getting the 1800W Aldi plate. I think the...