Search:

I started a thread last year on work I'd been doing with the G35 (and the C34 which has a slightly less aggressive pitch but is a far easier fit due to different offset ring placement)
...

http://www.ebay.com.au/itm/CSA4-19MG-MURATA-CERAMIC-RESONATOR-30PF-0-5-4-1900MHZ-CMOS-2-PIN-RADIAL-/111649253264?hash=item19fed06790:g:P~oAAOSwEeFVMXLs
...

you can get the actual proper speed oscillator - I bought half a dozen from a US elec component seller. approx $20 got the lot incl delivery

just checked and now cheaper to buy out of germany
...

have you looked at the 4.19mhz oscillator? its the thing that invariably gets replaced by instrument repairers

I've still got LED cooled inserts in the Mav. absolute woftam. good on low beam, useless on high beam. imaging was woeful. vanilla inserts are a compromise. wrong focal length, diffusion is...

wasn't suggesting that - it was an observation being made as there can be an opportunity for tribalism to take hold - and it last manifested itself around the time that P4x4 had site problems.

the...

registered on both

the other one is my main one - and thats really only because it was the first I started to look at before registering as a member
lurk on here, but tend to find that all the...

you can use the standard GM 0-90 Ohm sender - far more reliable (1965-1995 IIRC, single pin type) You can also use the later models found in Silverados (1995+) that are 3 pins, but its a bit of...

I'd buy BAJA if RooSystems wasn't the distributor.

I should have bought from the US before he became the agent

I even asked BAJA in the US if they had an NZ agent I c ould refer to, unfort no...

I just used silicon on mine - 50,000+ k's later and no dramas

and there's the example of different experiences. :) mine here was not as flash when I first came in. it's a moving feast. the forum temperament is diff on both forums.

ironically most of the...

I'm on both forums. In fact I think this was the first Nissan Oz forum I registered on.

I've got a low toleration for numpties, and they exist on both forums. I ignore the numpties and get on with...

there's a few blokes on patrol4x4 that have done it. GQShayne etc... IIRC there are happy snaps of the job.

someone also put in Honda CRV's as well as the usual crapadore VN-VY's

Controlled release... bearing pullers are your friend... :) once you get the first "crack" of release, its basically a controlled event...

if you yank it about a like a mad cats whiskers then you...

no idea about what it came off as it wasn't an original for the pulsar it was pulled off. It came from a wrecker in Queanbeyan - I wouldn't go there again as he was an absolute knob. I'd pay more...