Search:

I have never replaced them, although I've replaced the bleed line a few times.

That part I had dramas with was after replacing all fuel tubes, where the bleed line attaches to the metal return...

personally I'd replace while you got access if you got them ready to go, keep the old ones as spares

They break easily when doing them up, not undoing them. It's not the main body that breaks, it's the little bit that the positive power rail connects to.

Mine came out no worries, 2008 with...

I've reused the injector tubes multiple times with no ill-effect, just keep them clean. I replaced them after my last tear down for peace of mind.

I just tightened them as much as practical, nice...

No, probably 3-4 times a year. I enjoy watching dirty oil come out and putting clean stuff in. It's like mowing grass, or burning wood, very satisfying.

Anyone else love servicing their vehicle?

Going over my service intervals for the time I've had the patrol...

3,806
2,462
3,728
3,814
4,196
2,912

Good point. The earth is probably the most overlooked asset of any vehicle.

Hi mate. My name is Jay too.

Heck yeah!

I did some research a few years ago and settled with "fuel doctor" to mitigate water & algae. I keep a sauce bottle in my driver door and squirt a bit in each time before adding fuel

Don't buy it...

My best effort was Kelmscott WA to Yungaburra FNQ in 4 day and 5hrs. No alcohol. No drugs. Plenty of sleep. When I'd get fuel I'd fill a couple of jerry cans, when I'd stop for a piss I'd tip the...

Evolution takes millions of years, not a couple of hundred. They haven't evolved to navigate traffic yet.

Thanks for posting!

Never cleaned a chain yet, usually just lube and sharpen. Will give it a go now

Glad you have the freedom to be able to walk away from your job!

Congrats

It can run like crap without an error code, I've done it when I forgot to tighten an intake clamp.

there are two blanking plates available. you can blank at both ends to reduce intake/exhaust...

It's very satisfying when aftermarket things fit perfectly :D

Welcome mate!

I hope to find out one day

I bought a black wolf one years back, the annoying thing was the width spec referred to the mattress being completely flat/deflated so when it was naturally inflated it was narrower than advertised....

What's difficult about it?

Still got the patrol, but also bought an MG ZS EV which I put the most kms on.

flushed my radiator until it was clean

What has made me happy today is I finally got my beast back together today and running sweet, I started in June last year, I don't like to rush things.

New timing chain, new injector pump seals,...

The tubes are gonna have to come off to put a new valve cover, more importantly, do you really need a new valve cover? I just had mine off, I think there was a rubbery ring inside the cover that...

The proposition looks viable to me :)

I did the same thing with a D250S although just had a small length of cable I kept ready to screw into position between the start & aux terminals on the Ctek...

mine was leaking like crazy, i just replaced it

the torque is 10-11nm, maybe loosen and re-torque?

87291