Yeah was thinking of the 3 way switch. I have wiring there for my old spotlight I had .... before it got torn off. So was thinking of using that and changing switch over to suit
Its great i can...
Yeah was thinking of the 3 way switch. I have wiring there for my old spotlight I had .... before it got torn off. So was thinking of using that and changing switch over to suit
Its great i can...
Fitted a Uneek rear bar. Picked it up on Gumtree. Wrong colour but thats easily sorted.
Just got to change reverse camera to a flush mount type and wire up an over ride switch for the reverse lights...
Fitted LED h4 globes a couple of weeks ago. Finished doing LED indicator and park lights today to match it all in.
Replaced stock flasher unit with Narva one so no hyper flashing.
All working...
Heres a screen shot of it relating to the shackles and chain
http://www.nissanpatrol.com.au/forums/images/imported/2018/05/75.jpg
Sent from my SM-G920I using Tapatalk
As far as rigging onsite yes many riggers usually seat the pin then back off 1/4 turn. If used like this the rigger and/ or the site the pin would be moused so that it does not come loose. Now i do...
Not picking fights here , whilst you are correct in the breaking strain vs swl / wll you should never exceed the SWL of anything used. The safety factor is there for a reason.
Yes there is a safety...
The older VK56 motors had issues with timing chains stretching on the LHS i think it was. Not sure about the newer versions.
Have a search on google and it will show up in a few of the US based...
Diff lock light will flash until its engaged. Once it is engaged it will stay light solid. Sometimes takes a bit to engage with the factory solenoids. Few slow tight turns left to right usually help...
MB still not enough though as people are still getting hurt or killed by bad practices or misinformation/ misuse of the gear used. If this forum has prevented at least one injury or death from the...
Just because your point is rated to 5000kg doesnt mean you can swing 5000kg off it.
Many other factors can come into play. Chassis strength and the actual condition (eg rust inside) of it being one....
As long as its a grade 8 bolt and above i dont see an issue with it. Which is what you have bought.
Going back to rigging we could not use anything less than grade 8 or above to lift / pull . Very...
Have you pulled the vac hoses off the diff solenoid or checked them for damage? If the vac line to keep the actuator out (disengaged) it could be creeping back a touch just enough to trip the sensor...
Switch may be stuffed possibly or check the sensor wire on the back of the diff. Maybe thats fell off
Sent from my SM-G920I using Tapatalk
Wish i got 13.5 anywhere close out of my TB48 [emoji16]
Pretty sure the original fuel consumption listing for them was just written as LOTS and not as a number
Sent from my SM-G920I using Tapatalk
Wont be long til the rest of the country follows suit i think.
The new inspection laws seem a bit rough IMO. I do get the issue with cars with serious defects sticking out like dogs balls though...