ok heres the deal , where the main harness comes through the firewall into the engine bay on the drivers side the harness pushes against the inner guard this harness is not covered in anything other...
ok heres the deal , where the main harness comes through the firewall into the engine bay on the drivers side the harness pushes against the inner guard this harness is not covered in anything other...
today i added a hoop to my cheezy bar and added the driving lights took 6 months to get around to it but i got it done here is a couple off shots of the finished job,
i drive a lot of nights and the...
thought i would put a couple of full size photos in too
Today i pulled the slide rear side windows out of my patrol it took just 1 hour and 15 minutes including set up locate tools and clean windows ,i use venetian blind cord to pull the rubbers in on...
hi , i just put 2 crystal semi sealed beams in for $30 each plusa set of narva plus 50% h4 60/55 watt globes at $10 each, these globes cause no extra load on your wiring at all , turned out the best...
hey maxblack,
i had a massive vibration caused by the air volume travelling down the snorkel ,to fix it the fitters put a device in the snorkel as recommended by the manufacturer which turned out...
I brought this back home to Tuncurry last month it was sold by the Nissan dealer here in town and went south to the Central coast for a few years , sadly since new it inherited this awfull bullbar it...
just did mine today same problem as yours , i had new bearings done and all the seals too also new tyres and a balance in the last week and the local mechanic wanted to pull it apart and do some...