MC97GQ
15th March 2012, 06:28 PM
Hi,
I have just received my Digital Pyro and Boost Gauges from Auber Instruments and am now looking for the best advice as to where to fit the probes.
For the EGT probe, I was thinking here(see image below) as I can remove that section of pipe from the turbo to the tail pipe to drill the hole and remove all the metal filings.
13553
For the MAP sensor I thought about removing the four bolts from where intake come into the inlet manifold and drilling a hole below where the silicon pipe comes in, which saves having to take the whole inlet manifold off.(see image below)
13554
Would these spots be OK and would I get reasonably accurate readings, any help and advice is greatly appreciated
I will hopefully get some photos while I'm doing the job and do a bit of a write up for those who might be interested.
Mark
I have just received my Digital Pyro and Boost Gauges from Auber Instruments and am now looking for the best advice as to where to fit the probes.
For the EGT probe, I was thinking here(see image below) as I can remove that section of pipe from the turbo to the tail pipe to drill the hole and remove all the metal filings.
13553
For the MAP sensor I thought about removing the four bolts from where intake come into the inlet manifold and drilling a hole below where the silicon pipe comes in, which saves having to take the whole inlet manifold off.(see image below)
13554
Would these spots be OK and would I get reasonably accurate readings, any help and advice is greatly appreciated
I will hopefully get some photos while I'm doing the job and do a bit of a write up for those who might be interested.
Mark