ipatrol26
22nd December 2011, 12:30 PM
HELLO, any suggestions, thoughts or opinion on my project:
As some of you might know I am doing a weird conversion (Putting a n/a SD33 engine and tranny inside of a 92 GQ) and before anyone can suggest, this is my only affordable option at the moment at least until I can get the real deal. MY MAJOR CONCERN IS since the SD33 transfer case is offset to the right and my GQ rear diff is in the center the rear shaft will be a bit offset as well, by thinking it over it might not work but by looking at it its not so bad and besides its pretty much the same angle as you would have when lifting the truck high up and having the rear shaft drop down from the transfer to the diff.
Can any body tell me any suggestions on this, what are the pros and cons.
PS
I´ve seen and hear about people with the same issue and it seems to work just fine although every case differs from each other.
Thanks.
As some of you might know I am doing a weird conversion (Putting a n/a SD33 engine and tranny inside of a 92 GQ) and before anyone can suggest, this is my only affordable option at the moment at least until I can get the real deal. MY MAJOR CONCERN IS since the SD33 transfer case is offset to the right and my GQ rear diff is in the center the rear shaft will be a bit offset as well, by thinking it over it might not work but by looking at it its not so bad and besides its pretty much the same angle as you would have when lifting the truck high up and having the rear shaft drop down from the transfer to the diff.
Can any body tell me any suggestions on this, what are the pros and cons.
PS
I´ve seen and hear about people with the same issue and it seems to work just fine although every case differs from each other.
Thanks.