HELP tappet specs GU td42t

[dads tractor]

Gday can someone give the specs tappet clearances for the td42t GU 1999 I had the the manwells but that puter fused the twin hard drives so nothing retrieved. So I'm short for the 25 posts which I can understand the rules .PLEASE

[Bigrig]

Gday can someone give the specs tappet clearances for the td42t GU 1999 I had the the manwells but that puter fused the twin hard drives so nothing retrieved. So I'm short for the 25 posts which I can understand the rules .PLEASE

Someone will grab them for you mate - no doubt. I don't have that manual (tb42e for me), but others who do or who know the specs will grab them for you I'm sure.

[dads tractor]

thanks mate up and ddown to shed so a bit slow with a reply .

I'd rather have a bottle infront of me than a frontal labotomy or i'd rather be looking at it than for it cheers

[AB]

Hey mate have you had a look at GU manual on our site?

I'm pretty sure it has the tappet specs in there....

Just realised you don't have 25 posts yet....Go welcome some new members quickly and download the manual when you get to 25 posts mate.

[Bob]

According to the Manual that I have it is .35mm or .14Inch for both Inlet and Oultlet Tappets

Since found this

Adjusting Intake and Exhaust Valve Clearance
Adjustment should be made while engine is warm but not
running.
1. Set No. 1 cylinder in top dead center on its compression stroke,
and adjust valve clearance 1 , 2 , 4 , 5 , 8 and 9 .
2. Set No. 6 cylinder at top dead center on its compression stroke,
and adjust valve clearance 3 , 6 , 7 , 10 , 11 and 12 .
Valve clearance:
Intake 1 , 3 , 5 , 7 , 9 and 11
0.30 - 0.40 mm (0.012 - 0.016 in)
Exhaust 2 ,4 , 6 , 8 , 10 and 12
0.30 - 0.40 mm (0.012 - 0.016 in)
Adjusting screw lock nuts:
: 15 - 20 N×m (1.5 - 2.0 kg-m, 11 - 14 ft-lb)
I Tighten lock nuts, by fixing the adjusting screws using a minus
driver.
Checking

[dads tractor]

Thanks Bob back down to the shed to get oily and check them. Slowly working towards that post count :p