greetings

[Marinko Jezabek]

Hi to all fellow patrol owners/devotees.Just registered after becoming aware of site from patrolapart-the patrol part supply specialist located in Lilydale, Melbourne. Look forward to conversing with you all. Very impressed with the ability to download manuals and I am currently chasing information in realtion to the injector replacement job I am currently performing on my own GQ patrol. The issue is as follows. The injection nozzle washer has a groove running around it .Flip the washer over and you find the groove causes a protrusion or raised surface area. When I extracted these washers the protrusions faced upwards however my manual shows the groove facing upwards and not the protrusion.I tend to believe the manual as it is a genuine nissan Y60 supplement for an RD28T motor which means the washers were installed incorrectly by whoever serviced them before I owned it. So i thought I would try to cross reference it with the gregorys manual.If any one has any thoughts on this I would like to hear from you

Marinko

[nowoolies]

g`day Marinko
welcome on board mate
heaps of laughs and bucket loads of info here enjoy
nowoolies
Paul
p:s piccies we luv piccies

[growler2058]

Gday mate welcome aboard theyre a good mob here full of great info and advice

[YNOT]

Welcome to the forum Marinko.

I don't think it's critical which way the washer sits or the engine would not have been running properly previously. That said I would install them the way the factory manual shows just to be sure.

Tony

[Dhuck]

Welcome to the forum mate

[Sir Roofy]

marinko welcome aboard enjoy your stay
lots of info on here

[AB]

Welcome to the forum mate, feel free to ask any questions and join in the conversations.

[Finly Owner]

Hi and welcome to Nissans Nut House


Tim

[DX grunt]

G'day Marinko.

Welcome to the forum and great to have you onboard.

Take care out there.

Rossco

[Clunk]

g'day Marinko and welcome aboard mate

[Maxhead]

G'Day Marinko, welcome to the forum mate

[Bigrig]

G'day mate - Welcome aboard. Great people, information and laughs to be found on the forum, so don't be shy and join to make the most of it. Enjoy!

[Bob]

Welcome Marinko. Join in and enjoy

[Woof]

Welcome to the forum Marinko, enjoy mate........won't take long for you to get the required 25 posts up then you will have access to the manuals.

[teleman]

G'day there. Im not far from lillydale and was wondering if you could let me know the address?
Happy hunting.

[timbar]

G'day Mate - Welcome aboard join in when you are ready and have fun mate plenty to do see and if u have any problems just ask and im sure u will get an answer !! Bucket loads of usefull information here plenty to read so join in meet the great bunch of guys and girls on our wonderful forum !!

You will not be disapointed !!


ENJOY and WELCOME


Tim

[Phil21]

Hi & welcome to the forum, enjoy!!