diesel79
15th July 2011, 08:38 PM
Ok so I have a new toy :)
I know what I want to do (I think) but wouldn't mind some advice from you guys out there who have been there & done it before. I haven't and I am not at all mechanically minded :jawdrop:
Have had a couple of mods done already - Bullbar, Driving Lights, Snorkel Dual Battery & Cooper ST's & still want to add - UHF, Side Rails / Steps, Rear Bar, Suspension Lift, Drawers, Fridge, Winch & front E-locker. (hopefully I don't end up over the GVM)
Pretty straight forward for me so far, one concern I have is recovery points I have done plenty of reading on this and everyone has a different opinion, I believe I will be able to snatch off the rear bar when done? As for the front I am not keen on using the hook thats already there, can anyone suggest the best place to get these fitted (Melb Area?) I want to put 2 on to spread the load, I am not fussed where I have to travel to get it done I just want it done right (not a fan of recovery)
Next is Chips & Exhausts being a brand new car I am concerned about warranty etc, have seen sites that say just take it out before you take the car into a dealership, Is it that simple? and if it is do you just plug it back in again?
These weren't mods I had even considered doing until someone mentioned it, Should I do this & if I were to would you suggest getting all my other mods done first?
Thanks
Rachel
I know what I want to do (I think) but wouldn't mind some advice from you guys out there who have been there & done it before. I haven't and I am not at all mechanically minded :jawdrop:
Have had a couple of mods done already - Bullbar, Driving Lights, Snorkel Dual Battery & Cooper ST's & still want to add - UHF, Side Rails / Steps, Rear Bar, Suspension Lift, Drawers, Fridge, Winch & front E-locker. (hopefully I don't end up over the GVM)
Pretty straight forward for me so far, one concern I have is recovery points I have done plenty of reading on this and everyone has a different opinion, I believe I will be able to snatch off the rear bar when done? As for the front I am not keen on using the hook thats already there, can anyone suggest the best place to get these fitted (Melb Area?) I want to put 2 on to spread the load, I am not fussed where I have to travel to get it done I just want it done right (not a fan of recovery)
Next is Chips & Exhausts being a brand new car I am concerned about warranty etc, have seen sites that say just take it out before you take the car into a dealership, Is it that simple? and if it is do you just plug it back in again?
These weren't mods I had even considered doing until someone mentioned it, Should I do this & if I were to would you suggest getting all my other mods done first?
Thanks
Rachel