Cremulator
6th October 2018, 03:45 PM
I made this bracket while trying to fabricate a mount for my catch can, but I folded it too short to mount the catch can on to it.
It has holes drilled that fit the factory points in the engine bay and on the side panel of a GU III.
You can see where it mounts on the reference pic with my catch can bolted to the final version I made.
The front face is 110mm x 40mm.
If someone could use it to mount something in their engine bay, it's going free.
Pick up inner north-eastern suburbs of Melbourne.
I'd rather not post it preferably.7653776539
It has holes drilled that fit the factory points in the engine bay and on the side panel of a GU III.
You can see where it mounts on the reference pic with my catch can bolted to the final version I made.
The front face is 110mm x 40mm.
If someone could use it to mount something in their engine bay, it's going free.
Pick up inner north-eastern suburbs of Melbourne.
I'd rather not post it preferably.7653776539