My gq drawes

[stevsr31]

Hi here are the drawes I made did not think to take any shots till after I started work fine :)

[Bigrig]

Hi here are the drawes I made did not think to take any shots till after I started work fine :)

Very neat and tidy job mate!!

[AB]

Very impressive mate!

Ten times better then my timber ones...LMAO

[NissanGQ4.2]

Very neat and tidy job mate!!

x2 very nice

[Clunk]

them there are some pretty saucy looking drawers mate

[growler2058]

Very good job mate well done

[nowoolies]

not three bad at all ............where`s mine?????

[fixer982]

Nice work Steve. I wish I could work metal like you obviously can. If I had made mine out of metal, even with a MIG they would look like swiss cheese.
My timber ones are not that neat now, though I was pretty proud of them when I first made them. I used the sliding shelves from a computer rack, which have pretty good ball bearing runners.
The most expensive part was the marine ply and they are a bit heavy, but cheaper than ARB etc. Pity I made them a bit higher than I would like but they hold lots of s**t.

[mooney]

how did you make the fridge slider part

[jazza_v]

very nice good job

[sibbles]

Love it, do you have all your slides on bearing and no commercial sliders in them. Did you make the sliders from steel or aluminum?

[Dapple]

Nice job did you shape the metal yourself or did you buy it like that?

[thebeatjackson]

looking good mate, might need something like that for my truck!