PDA

View Full Version : Control Unit



MrPekko
23rd April 2017, 02:19 AM
Someone who has a clue what this is?

Turtle_au
23rd April 2017, 02:24 AM
What model/engine?
Where is it mounted?
Looks like diesel engine pre-heat control. (Glow plugs or manifold heater.)

Sent from my SM-T355Y using Tapatalk

MrPekko
23rd April 2017, 03:18 AM
Model 2004, Y61, inside and a looong cable into the engine compartment

Jimmyboyjr4
23rd April 2017, 04:10 AM
Its the ECU I believe

http://www.worldecu.com/en/Ecu-engine-controller-nissan-patrol-w11ek-23710-vc360-23710vc360

MrPekko
23rd April 2017, 05:24 AM
Thanks!! Jimmy

MrPekko
23rd April 2017, 03:14 PM
Any idea where I will put it again? Have been hanging since I bought the car.

dom14
23rd April 2017, 10:06 PM
Any idea where I will put it again? Have been hanging since I bought the car.

That's a good sign that somebody's been fiddling with it. It should be secured 'cos it looks like the ECU.

Jimmyboyjr4
23rd April 2017, 10:51 PM
Not entirely sure where is goes but if you judge via the cable lengths you should a general idea of where it goes. Try looking for any captive nuts or slots it could be bolted too, should help you figure out where it lives.

NissanGQ4.2
24th April 2017, 07:22 AM
Not sure on the GU's but on the GQ's the ECU is located behind the passengers side firewall.

The thread below will show you how its mounted

http://www.nissanpatrol.com.au/forums/showthread.php?2706-GQ-4-2-EFI-ECU-(-Engine-Control-Unit-)&highlight=Engine+control+unit%3B.

When you get a chance can you pop into the introduction section of the forum ( link can be found in my signature ) and post up an intro about urself and ur rig.

Cheers

Toddie