Zd30 crd (limp mode) no power

[Rsayers]

Hi guys

Now I'm having trouble with my ute
Starts fine runs fine except I seem to be
Going to limp mode (loss of power) and engine light on
It's boosting fine 17psi.
Don't seem to be any leaks, checked oil filter seems
Good. Can't put my finger on it any help or
Ideas would be greatly appreciated.

I have egr blocked completely (both sides)
Egr delete , full nads


Also can't put it on the scanner seems to
Have no power to where it plugs into, any ideas.

[Maxhead]

I would pull all that crap you have on there( otherwise called nads) and try again;)







................on the road

[happygu]

Leave the EGR blocked initially, and put all the hoses back to standard, and see what happens....

If it still continues, try putting the EGR back to standard too, as there are some that just like the 10mm Hole in the Blanking Plate to be happy.

[threedogs]

I would of backed the boost off a tad to say 15-16psi
dis connecting the battery as you do it,,,, for 1/2hr or so
see how that goes.

[Turtle_au]

I would suspect ECU if it won't scan.

Sent from my SM-T355Y using Tapatalk

[mudski]

Hi guys

Now I'm having trouble with my ute......

Also can't put it on the scanner seems to
Have no power to where it plugs into, any ideas.

What scanner are you using? The scanner might not be compatible, or even not working.

[Rsayers]

What scanner are you using? The scanner might not be compatible, or even not working.


Scanner works and has worked on this ute before, I've tested it to see if power
Is getting to the plug and it seems only a few of the pins are actually getting power
I've put 4 different scanners on it with the same result