UHF Power Adpater

[gubigfish]

Hi All,

I had a Uniden UHF thats been playing up so replacing it with an ICOM. The power from the uniden was rectangular 3 pin with only 2 in use

69943
69944

This is the ICOM supplied Power lead

69945

Anyone know if you can get adapters so I don't have to replace the existing power cable?

Cheers
Fish

[threedogs]

You could try JayCar they have all kinds of plug ends.
its only pos and neg so you could buy a new set
dont forget to fuse it

[NissanGQ4.2]

Just cut the Uniden plug off and join the new plug? Easier than trying to source any type of adapters

[gubigfish]

Was trying to avoid cutting the supplied cable. Found both types of connector at Jaycar for anyone else looking to do this in future.

[GeeYou8]

The Icom connector is a bit more substantial than the Uniden, the cable looks heavier, it is probably worth the effort to rewire & eliminate any possible faults. Adapters are not a good permanent solution.
If you cut the Uniden connector off you can use the old wire to pull the new one back through the firewall, I would use a relay to switch power on when ignition is on.
Graham