PDA

View Full Version : Gu patrol help


davidsgu
5th June 2016, 11:09 AM
Hey everyone I own a 2009 gu patrol crd it has just started making a whining noise when cold not sure if it is exhaust manifold which was replaced 14 months ago just before I bought the car or if it is coming from turbo https://vimeo.com/169392142



Sent from my iPhone using Tapatalk
LostBenji
5th June 2016, 11:26 AM
Details of GU?
What donk?
LostBenji
5th June 2016, 11:32 AM
Besides the first issue with VVS.. https://www.youtube.com/watch?v=Bt9zSfinwFA

Looks like stocker with no NADS. Pull vac line off the VNT actuator when running. The VNT should open back up. If it does, then the actuator is fine.

The noise though sounds like the bearings in the turbo core are shot and the compressor or turbine are hitting the housing. The only real way to know is to pull the exhaust dump off and put finger on back of shaft and feel for free-play.
That being said, the noise is rev dependent, not matching what would be going on with turbo. Look around the front of the motor for any bearings that maybe gone. For example, the belt tensioner, AC compressor or alternator.
threedogs
5th June 2016, 12:02 PM
could also be a split EGR pipe , quite common
along with a warped manifold
Also check the clutch pulley on the alternator.
A long screwdriver or piece of hose may help you
isolate the noise better
BigRAWesty
5th June 2016, 01:25 PM
That's a weird one.. and very sudden..
All I can suggest is take a long screw driver and hold the tip against the turbo housing and the handle against your upper jaw bone near your ear lobe.. this will resinate noises past the squeal into your ear..

Is it consists?
Does it happen only above a certain rpm?
Does it dissappear when you lift off the throttle at higher rpm?
davidsgu
5th June 2016, 07:06 PM
Only when cold and around 2500rpm but if I remove the vacuum me line to actuator it stops


Sent from my iPhone using Tapatalk
davidsgu
5th June 2016, 07:30 PM
https://vimeo.com/169413892


Sent from my iPhone using Tapatalk
BigRAWesty
5th June 2016, 08:02 PM
Ok so as soon as your adding boost it's screaming.
So have you checked for boost leaks. Soapy water on all the joins?
LostBenji
5th June 2016, 08:13 PM
Dump pipe off and check shaft play. If it wobbles, she is farked.

P.S If it is farked, you are putting metal shavings into the motor.
luckyphil
21st June 2016, 08:35 PM
Davidgu

did you resolve this noise ? I have exactly the same noise coming from mine.
Jimmy_Fatspliff
1st July 2016, 06:13 AM
Sounds like the exhaust manifold to me. Mine was making a similar noise. The manifold warping is a common problem with these. You'll have to pull it off and get it machined. It's a bit of a root around. Not expensive to get it machined. Look around online for a gasket kit.
Being that it only does it when it's cold makes sense because as the heat expands the manifold the gap will close up and re seal.