zd30 crd top dead center

[robewott]

I've put another oil pump into my cr patrol & after putting it back together it would not start. So i've pulled the timing cover off again to make sure the timing was ok. It all lines up with the second mark on the crankshaft pulley(standing in front of the engine & turning it clockwise). The yellow link is in the right place as is the blue links & the cams. The workshop manual does not mention anything about two marks on the pulley.
Is this correct?

[SupRob]

I believe they way they call the gears are hunter geared,

It will take XX amount of turns to align up, on the balancer there should be Two timing marks.

All i remember was keep turning untill the 1st piston was a TDC which aligned with the crank pully markings which then everything aligned up :)

Goodluck