View Full Version : how to remove slipyoke from drive shaft
MeedPatrol
17th April 2015, 11:36 PM
I have a front drive shaft 37200 G9 801 ( doubble joint on one side ). I think from a Nissan Patrol 260.
I want to remove the 'slip yoke'
I can remove the rubber sealing but I can't get the yoke from the drive shaft
Anyone know of a document or movie how to do this?
I would be very grateful.
regards57318
Woof
18th April 2015, 10:48 AM
Hey mate, head over here and post up an introduction http://www.nissanpatrol.com.au/forums/forumdisplay.php?2-Introductions nice thing to do before asking for assistance
dom14
19th April 2015, 04:47 PM
It's not meant to come out that easily, is it?
But, I can't help wondering about the reason you want it removed!
MeedPatrol
21st April 2015, 05:31 AM
It's not meant to come out that easily, is it?
But, I can't help wondering about the reason you want it removed!
I want to change the slip yoke for a longer one.
Is there an extra part I should remove before I can take out the slip yoke from the axle?
BigRAWesty
21st April 2015, 08:21 AM
Sort bloke I'm pretty sure the shaft is inserted before being welded onto the pipes.
So the only way of getting it out, is cutting it up.
Take it to a drive line specialist and get them to extend it for you
MeedPatrol
24th April 2015, 04:06 PM
that seems to be a little bit strange.
There are plenty of spare slip yoke parts on the market.
So cutting? There must be a normal way to do it.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.