Best way to get boost for gauge and nads from gu series 3 zd30

[markstevo]

Hi I have read a bit about where to get the boost from as there is no specific point There is an adaptor plate you can buy that incorporates the MAF sensor is this good or should I just tap into the turbo pipe after the intercooler and weld the outlet on whats the best way? I am installing NADS and was wondering if I get the plate near the MAF sensor will this also work for the requirments for NADS as that will need it as well

[threedogs]

which ever way you go will work that adaptor plate is east to fit.,
http://www.ebay.com.au/itm/Quick-Fit-Boost-Gauge-Adapter-Spacer-Kit-Nissan-Patrol-New-Design-/361223165642?pt=LH_DefaultDomain_15&hash=item541a9416ca

Also most here have a dual pillar pod for boost and EGT gauges

Not sure what the plate near the MAF is, once NADDED lol you control the boost no more limp mode
Is your IC oily if so that may need a tigged replacement as hard to adjust boost when its leaking out

[markstevo]

Just ordered the adaptor online this will make it alot easier then drilling and welding pipes. Thanks for help and it is the plate I was reffering to just used wrong name for it.