Flex
7th December 2014, 02:00 PM
A while back I was playing with my GU drivers side window switch module trying to make it work without the key and I found that Nissan (or Niles, Nissan's supplier) had design it so you could have LEDs under all the switches. So I set to work to add them in
First was to find the correct LED that Nissan had used, so I order a whole bunch of LEDs from different manufactures to match the colour with the original one. Below is my testing:
52430 52420
Next was to brightness match them new LEDs with the rest of the car interior lighting. Nissan had used the most odd size resistors in their design so it was very hard for me to source them, I eventually sourced them and soldered them onto the circuit board:
52419
This is the the switch module installed into the car:
52429
For anyone wishing to do the same to their car below are the steps:
Remove the module from the car
52422
Disassemble the module removing the white base from the house by the 4 clips around the side
52421
Un-solder the white base from the circuit board as you need to access the top of the circuit board
52423
You won't have these wires, these were my power feeds during testing
Solder 5 (I replace the original LED as well) LEDs onto the PCB at the red circled locations:
52424
Solder 2 1210 size 4.7K ohm resistors at these locations:
52425
Then another 1210 size 4.7K ohm resistor here (on the top of the circuit board)
52426
Solder a 2010 size 4.7K ohm resistor here
52427
Solder a 2010 size 2K ohm resistor here
52428
Re-solder the white base to the circuit board
Assembly the white base/circuit board and switches
First was to find the correct LED that Nissan had used, so I order a whole bunch of LEDs from different manufactures to match the colour with the original one. Below is my testing:
52430 52420
Next was to brightness match them new LEDs with the rest of the car interior lighting. Nissan had used the most odd size resistors in their design so it was very hard for me to source them, I eventually sourced them and soldered them onto the circuit board:
52419
This is the the switch module installed into the car:
52429
For anyone wishing to do the same to their car below are the steps:
Remove the module from the car
52422
Disassemble the module removing the white base from the house by the 4 clips around the side
52421
Un-solder the white base from the circuit board as you need to access the top of the circuit board
52423
You won't have these wires, these were my power feeds during testing
Solder 5 (I replace the original LED as well) LEDs onto the PCB at the red circled locations:
52424
Solder 2 1210 size 4.7K ohm resistors at these locations:
52425
Then another 1210 size 4.7K ohm resistor here (on the top of the circuit board)
52426
Solder a 2010 size 4.7K ohm resistor here
52427
Solder a 2010 size 2K ohm resistor here
52428
Re-solder the white base to the circuit board
Assembly the white base/circuit board and switches