Sharky1
22nd October 2014, 02:54 PM
Has anyone ever been successful in finding a replacement boot for the slip joint on a GU (TD42 1998)? If so where did you find it or what did you use instead?
Nissan want to sell me a complete tail shaft. I've called all the driveshaft & CV specialists I know & they have the same problem. Someone has to make them. I've looked online too.
The only thing I've seen in the past that's similar is something for a swimming pool or dunny but trying to find the right size will be near impossible.
Wreckers don't want to separate them either.
I haven't pulled mine off to measure it yet but I reckon it's about 35mm diameter one end & 60mm the other & prob about 50mm long.
It's freakin annoying coz mine was in good shape until we had to winch the car through a river & it jagged itself on a rock.
Nissan want to sell me a complete tail shaft. I've called all the driveshaft & CV specialists I know & they have the same problem. Someone has to make them. I've looked online too.
The only thing I've seen in the past that's similar is something for a swimming pool or dunny but trying to find the right size will be near impossible.
Wreckers don't want to separate them either.
I haven't pulled mine off to measure it yet but I reckon it's about 35mm diameter one end & 60mm the other & prob about 50mm long.
It's freakin annoying coz mine was in good shape until we had to winch the car through a river & it jagged itself on a rock.