Chappy
13th October 2014, 09:37 AM
Hey guys,
Since I finished my conversion I've had a nasty fuel leak. Over the weekend I narrowed it down to injector's 5 & 6. My friend replaced my broken spill tube when the motor was out, I can recall him taking those two injectors out for some reason also.
I'm assuming that they haven't been tightened correctly, hence the leak. I'm not sure how to go about tightening them up without breaking anything, I've been told those tubes are quite fragile.
Would any of you fine fellows have any tips or directions on how to go about tightening it all up without breaking the lot?
Thanks
Since I finished my conversion I've had a nasty fuel leak. Over the weekend I narrowed it down to injector's 5 & 6. My friend replaced my broken spill tube when the motor was out, I can recall him taking those two injectors out for some reason also.
I'm assuming that they haven't been tightened correctly, hence the leak. I'm not sure how to go about tightening them up without breaking anything, I've been told those tubes are quite fragile.
Would any of you fine fellows have any tips or directions on how to go about tightening it all up without breaking the lot?
Thanks