View Full Version : Passenger door window loose
Hodge
16th September 2014, 08:55 AM
Just got to work and noticed my passenger window is loose and doesn't close all the way. Once its up as far as it goes I can move it up by hand about 10mm. Can also move it left and right about the same distance.
The other thing is, there is a gap between glass and seal 8-10mm as per photo can just about fit finger in.
Is there a common issue with this getting loose ??? I'll have to have a proper look once I'm home.
I'm just not sure whether someone tried to get in there last night by wedging something in there hence the gap. Or it rattled off sometime in the last few days . definitely wasn't like this before.
49370
Sent from my S4 using Forum Runner
Hodge
16th September 2014, 08:55 AM
49371
Sent from my S4 using Forum Runner
threedogs
16th September 2014, 10:55 AM
does it look like its been tampered with.?
Might just be a loose nut on the wind up arm thinghy
in side the door.? lol
Hodge
16th September 2014, 11:28 AM
Doesn't look like it... No visible marks or anything. Maybe something in there loosened off during the wombat mud bash and gave way... I haven't pulled the door that far before ill do it when I get home.
Sent from my S4 using Forum Runner
kevin07
16th September 2014, 12:40 PM
ther is a bar goes down the center of the door that the winder is attached to it is spot welded which does break have a look there if it is put it in place drill and rivet it. just asking though when it stops winding is it clicking like its trying to wind.
Hodge
16th September 2014, 12:54 PM
No clicking mate just goes up and down freely and stops as per usual except it don't close all the way. Will gut the door once I'm home and have a look.
I'm just puzzled why that gap is there. Window pushed in a tad ...
Sent from my S4 using Forum Runner
Hodge
16th September 2014, 07:23 PM
Ok, pretty sure I've fixed it. The glass slipped out of the white holders at the bottom for some reason ... Re-slotting the glass in the was simple enough. Why it slipped out, is unknown.
49389
menace 2
21st September 2014, 09:29 AM
because they should be glued in or held in with something mate so the winder arm doesn't come down and leave the window behind
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.