fit winch to tjm bullbar

[shan-747]

hi guys and girls i have a tjm bullbar and i was giving a roo systems 12000ibs winch has any one fitted these to there car and if so could you please put some pics up to have a look at if so that would be awesome :animierte-smilies-t

[MudRunnerTD]

Is the bullbar a winch bar? If it is then it should be pretty straight forward mate. Simple bolt up I'd reckon.

[shan-747]

Yea it is a winch bar but the person at tjm said I might have to stuff around a bit

[MudRunnerTD]

your only stuffing around i would think will be making sure the winch spools under and in the right direction, you may have to rotate the gear box to suit but this is common on the ARB and Nissan bars too.

[shan-747]

Ok well hopefully I dont have to lol

[MudRunnerTD]

Ok well hopefully I dont have to lol

its very simple to do if you need to mate. You might have to flip the winch and mount it upside down so then you would need to rotate the gearbox end 180 degrees and then mount it up.

[Irish]

Just be careful, some of the older TJM bars(even the winch ones) still need a reinforcing cradle for the winch as the bar itself is pretty thin.

Got one for the missus car and had to do a lot of ringing around and research to find out if I could just pop a winch in or if I needed the cradle.

Other than that, as has been said, you may just have to rotate the gearbox on it 90deg.

[shan-747]

Hope I dont need to do anything and it just goes in lol but thanks for the info

[shan-747]

I should have it next week so ill let yous know how I went