PDA

View Full Version : Oil leak on bell housing 2000 model GU 4500



Fairlane
20th September 2013, 09:10 PM
There is a slight weep of oil on the fbell housing.
is this typical and an easy fix?

Thanks!

AB
20th September 2013, 09:13 PM
Is it engine oil or transmission oil?

AB
20th September 2013, 09:16 PM
Is it on the bell housing or coming out of the drain of the housing?

Fairlane
20th September 2013, 09:59 PM
engine oil, looks like its on the bell housing

AB
20th September 2013, 10:05 PM
engine oil, looks like its on the bell housing

If it's on the bell housing and on the front of it then It's most likely engine oil off the engine and the problem is somewhere else.

Take the bung out of the bottom of the bell housing and make sure no oil is coming out of there to start off.

If that checks out then clean (degrease) your engine thoroughly, go for a drive for 30 minutes and then try to find out where It's leaking from?

NP99
20th September 2013, 10:19 PM
Could also be the rocker cover leaking at the rear.

Fairlane
20th September 2013, 10:49 PM
ok sounds good. thanks for the tip!

NP99
21st September 2013, 03:40 PM
Do you park it on level ground mate?

Fairlane
21st September 2013, 05:09 PM
yes it parks on level ground but i have only had it for three days!

AB
21st September 2013, 05:33 PM
Oil on front of bell housing could be dripping from anywhere from engine whilst driving.

Did you clean the engine today mate?

Robo
21st September 2013, 06:19 PM
The rocker cover bolts can leak to, not just the cover to head gasket/rubber.
Had a similar problem on TB42 it was either the rocker bolts or rear of head gasket.
I suspect mine was head gasket as silicon didn't help rocker cover at all.
hope yours is else where.

Fairlane
21st September 2013, 07:04 PM
job for tomorrow. been tinkering around all day and got nothing done, typical Saturday!