PDA

View Full Version : DIY disc rotor machining


NP99
19th June 2013, 05:51 PM
http://youtu.be/RdMFpuLCcxA

Crazy stuff..............
BigRAWesty
19th June 2013, 06:08 PM
I had a suspicion that's what it entailed..
I was then wondering how he does the inside face.. I then saw and that was it for me.. lol..

He should also have a side note, not for lsd vehicles...

Kallen Westbrook
Owner of
Westy's Accessories (http://www.nissanpatrol.com.au/forums/showthread.php?15134-Westy-s-Accessories.-A-small-back-yard-builder.)
Bloodyaussie
19th June 2013, 06:10 PM
I got bored waiting for it to load when I tried to fast forward. ...
Parksy
19th June 2013, 06:11 PM
Crazy stuff indeed. Even more so are the comments on some of the people saying its a good idea. Stupid, unsafe, and won't benefit in any way.
macca
19th June 2013, 07:08 PM
Skip to 5 minute mark at least!!!!!!
NP99
20th June 2013, 05:42 AM
There are a few more vids out there doing the same thing. DIY gone mad!
Cuppa
20th June 2013, 12:53 PM
There,s a bit of surface rust on my discs & I've got some axle stands & a 120 grit flap wheel. Think I'll give it a go. As I only have two axle stands & the discs are on the front, do you think it would be feasible to just jack the rear end up & block it up with a couple of lengths of firewood? I can cut them to the right length because I have a chainsaw. Maybe I should give the rear drums a bit of go too whilst I'm at it?















Joking folks! :)
BigRAWesty
20th June 2013, 12:55 PM
Don't forget the DIY thread cuppa...

Kallen Westbrook
Owner of
Westy's Accessories (http://www.nissanpatrol.com.au/forums/showthread.php?15134-Westy-s-Accessories.-A-small-back-yard-builder.)
NP99
20th June 2013, 07:09 PM
There,s a bit of surface rust on my discs & I've got some axle stands & a 120 grit flap wheel. Think I'll give it a go. As I only have two axle stands & the discs are on the front, do you think it would be feasible to just jack the rear end up & block it up with a couple of lengths of firewood? I can cut them to the right length because I have a chainsaw. Maybe I should give the rear drums a bit of go too whilst I'm at it?














Joking folks! :)
Could you loan me those blocks of wood? I have no stands.
BigRAWesty
20th June 2013, 08:14 PM
Could you loan me those blocks of wood? I have no stands.

Car jack one side, the 2 tires under the other... :D

Kallen Westbrook
Owner of
Westy's Accessories (http://www.nissanpatrol.com.au/forums/showthread.php?15134-Westy-s-Accessories.-A-small-back-yard-builder.)
NP99
21st June 2013, 07:58 AM
Car jack one side, the 2 tires under the other... :D

Kallen Westbrook
Owner of
Westy's Accessories (http://www.nissanpatrol.com.au/forums/showthread.php?15134-Westy-s-Accessories.-A-small-back-yard-builder.)

Or hollow beesa blocks maybe?