PDA

View Full Version : Back up/reverse switch.



Coldcomfort
17th March 2013, 01:42 PM
Gidday all, can someone tell me the physical location of the reverse switch for a manual 2012 ST patrol. Needed for the reverse camera trigger....

Cheers.

teno45
17th March 2013, 02:29 PM
Just as easy to run it from the reverse lights. Youll be running a video cable from the camera anyway.

Coldcomfort
17th March 2013, 04:24 PM
After a fair bit of trawling thru circuit diagrams and crawling under the car I found the two yellow wires that come out of the gear box. They roughly run under the drivers seat and go up towards the engine compartment. They get lost in the clutter just above the starter motor. If I can locate them closer to where the head unit is I will pick up the reverse camera trigger from there. Might be easier than running the length of the car to the reverseing lights....

Yendor
17th March 2013, 04:28 PM
You will find the harness for the tail lights in the LHS kick panel.

edit.... The connector is in the LHS kick panel as well.

NP99
17th March 2013, 06:13 PM
You will find the harness for the tail lights in the LHS kick panel.

edit.... The connector is in the LHS kick panel as well.

Is that loc for all models?

Coldcomfort
17th March 2013, 06:34 PM
You will find the harness for the tail lights in the LHS kick panel.

edit.... The connector is in the LHS kick panel as well.

very helpfull, thanks!!

Yendor
17th March 2013, 07:13 PM
Is that loc for all models?

GQs and GUs yes. I'm not sure about the earlier models.