mudski
31st May 2012, 10:26 PM
I got sick and tired of the birds nest under the dash from the previous owners so I went hell for leather and ripped everything out apart from what was in there from factory. This is the only part left to put back in and I've made myself a bit confused as I have wired in 3 pole illuminated switches for spotties before but not 4 pole.
I have made up a drawing on the two 4 pole switches I have and the wiring that was connected to them when I took them out. I didn't take notice of actually where these wires went to from the switches as I it was such a mess I could recognize anything under the dash.
So, I only want to use one of the switches for now but I leave them both fitted in the dash for the time being until my funds come up again for the roof mounted spotties. :)
So I know terminals 7 and 8 are for the light in the switch but you will see how its wired up so the switch lights only come on when the switch is turned on. If I just power up 7 & 8 they light up all the time. which i don't want.
So how would I connect this to the relay so that the switch light only comes on when I activate the high beams and spotties?
Just to note the relay is wired in, I have the signal wire coming from the high beam and into the dash. Just not sure where this signal wire should go.
Thanks.
http://img521.imageshack.us/img521/7751/switch4pole.jpg (http://imageshack.us/photo/my-images/521/switch4pole.jpg/)
Uploaded with ImageShack.us (http://imageshack.us)
I have made up a drawing on the two 4 pole switches I have and the wiring that was connected to them when I took them out. I didn't take notice of actually where these wires went to from the switches as I it was such a mess I could recognize anything under the dash.
So, I only want to use one of the switches for now but I leave them both fitted in the dash for the time being until my funds come up again for the roof mounted spotties. :)
So I know terminals 7 and 8 are for the light in the switch but you will see how its wired up so the switch lights only come on when the switch is turned on. If I just power up 7 & 8 they light up all the time. which i don't want.
So how would I connect this to the relay so that the switch light only comes on when I activate the high beams and spotties?
Just to note the relay is wired in, I have the signal wire coming from the high beam and into the dash. Just not sure where this signal wire should go.
Thanks.
http://img521.imageshack.us/img521/7751/switch4pole.jpg (http://imageshack.us/photo/my-images/521/switch4pole.jpg/)
Uploaded with ImageShack.us (http://imageshack.us)