Welcome to the Nissan Patrol forum. To post a question and to see less adds on the forum then you will have to register
first. We are an easy going friendly forum so join in the conversations and feel free to ask any questions.
Become a forum sponsor for only $20 and see no adds with faster page loading times and many extras benefits.
Its not necessary bud. Dont bother. you wont gain anything from doing it. The large butterfly assists in engine shut down, and the other i like a choke where it closes to richen the fuel mixture. Or something to that effect.
But if your keen to see the difference, just leave the vacuum tube of it so it wont work and just stay open.
Sent from my SM-P600 using Tapatalk
Last edited by mudski; 16th July 2016 at 10:28 PM.
As title. Why is this deemed a necessary mod?
EGR has been removed, and throttle body cleaned....
Wow thats some serious crud in that throttle body ,maybe have to check mine before i install the new intercooler i have a oil stain on my ic where it has been leaking so more than likely throttle body full of crud too ? just blocked the egr 2 days ago 20160715_152406.jpg
Why do caveman drag there woman by there hair ?
Cause if you drag them by there feet they fill up with dirt
Wow thats some serious crud in that throttle body ,maybe have to check mine before i install the new intercooler i have a oil stain on my ic where it has been leaking so more than likely throttle body full of crud too ? just blocked the egr 2 days ago 20160715_152406.jpg
You could remove your IC and clean the inside, Wouldnt bother testing it for leaks if its oily.
Diesel Smart do a great tigged IC pressure tested to 60 psi I think, good service too.
check that rear hose [blue] on yours they have a tendency to blow off or split
04 ST 3lt auto, not enough Mods to keep me happy, but getting there
You could remove your IC and clean the inside, Wouldnt bother testing it for leaks if its oily.
Diesel Smart do a great tigged IC pressure tested to 60 psi I think, good service too.
check that rear hose [blue] on yours they have a tendency to blow off or split
3D I have a new intrcooler arriving monday -tuesday i will prob get new hoses for all the pipework on the IC as they all look a bit dodgey
was thinking about going 2.25 inch (57mm) from turbo to intercooler had a look on ebay but found it hard to find all the parts needed
this is what i think is required
2.25inch (57mm) 90deg mandrell bent pipe
2.25inch(57mm) 60deg mandrell bent pipe
2.25inch (57mm) straight sillicone joiner x2
1.75inch to 2.25inch reducer silicone joiner
Why do caveman drag there woman by there hair ?
Cause if you drag them by there feet they fill up with dirt
Originally Posted by Daveyboyjunior
Posting Permissions
Reply With Quote
