-
24th September 2020, 06:00 PM
#1
TB42 Carby Insulator
Hi All,
I have been rebuilding the Carby and reassembling at the moment, the insulator between the throttle body and the main body had no gaskets when removed. The rebuild kit came with 2 gaskets, do I put one each side of the insulator or leave them out as it was when disassembled. I am concerned that it may be too thick with 2 gaskets and the insulator and cause running issues, if it was between the carby and the inlet manifold I feel it would be less of an issue but because it is between 2 sections of the carby I'm unsure if it will have any impact. Appreciate any input or advice.
-
-
24th September 2020 06:00 PM
# ADS
Circuit advertisement
-
24th September 2020, 09:47 PM
#2
Advanced
Originally Posted by
MickMc
Hi All,
I have been rebuilding the Carby and reassembling at the moment, the insulator between the throttle body and the main body had no gaskets when removed. The rebuild kit came with 2 gaskets, do I put one each side of the insulator or leave them out as it was when disassembled. I am concerned that it may be too thick with 2 gaskets and the insulator and cause running issues, if it was between the carby and the inlet manifold I feel it would be less of an issue but because it is between 2 sections of the carby I'm unsure if it will have any impact. Appreciate any input or advice.
I don’t know much but in brisbane I have had nothing but top advice from Northside Carburettors
Sent from my iPhone using Tapatalk
-
-
24th September 2020, 10:30 PM
#3
Thanks Nowlzy, I will give them a call and see if they can help.
-