Last edited by mudski; 15th December 2018 at 01:50 PM.
rusty_nail (15th December 2018)
Job soon - Front Hub dust & inner axle seals .
https://www.ebay.com.au/itm/141555690483
2008 GU WAG ST Manual CRD - To do the job
MB (22nd December 2018)
Almost $1000 in paint and accessories. Better than paying someone $7500 to do it.
Sent from my A1601 using Tapatalk
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
Never used these drivers before, only ever used brass dollies, sockets, blocks of wood etc. Should help for the deep seated seal.
Just that I changed out front rotors and pads a few months back and now noticed inner axle seal is weeping. Has been a few yrs since I greased the CV/knuckle joint anyway.
A few jobs lining up (dump pipe top gasket & wrap, and new 4" snorkel/airbox). Getting all my bits together, to do exhaust and induction at same time, now only waiting on 4" snorkel(in transit).
Induction Pipe - airbox to turbo arrived today.
2008 GU WAG ST Manual CRD - To do the job
MB (22nd December 2018)
Last edited by jay see; 21st December 2018 at 10:48 PM.
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
MB (22nd December 2018)
@mudski @MB
I've got more than enough on my plate at the moment..
Sent from my A1601 using Tapatalk
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
MB (22nd December 2018)