-
28th March 2020, 09:04 AM
#461
Looking good mate, coming along well.
-
The Following User Says Thank You to 10G For This Useful Post:
jay see (29th March 2020)
-
28th March 2020 09:04 AM
# ADS
Circuit advertisement
-
29th March 2020, 02:35 PM
#462
Legendary
-
The Following 2 Users Say Thank You to jay see For This Useful Post:
Cremulator (29th March 2020), rusty_nail (29th March 2020)
-
29th March 2020, 05:21 PM
#463
Daily Lurker
-
The Following User Says Thank You to rusty_nail For This Useful Post:
jay see (29th March 2020)
-
29th March 2020, 05:36 PM
#464
Expert
Awesome fabrication work to make it fit.. but I have to ask..... why?
Last edited by Mickhead; 29th March 2020 at 05:41 PM.
-
-
29th March 2020, 06:23 PM
#465
Legendary
Originally Posted by
Mickhead
Awesome fabrication work to make it fit.. but I have to ask..... why?
Why, because I can. It's what I do for work.
Nah, seriously if you go back about a week or so you'll see that with the strap it was pulling away. I was always going to make the other pieces just to neaten it all up.
Sent from my CPH1979 using Tapatalk
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
-
The Following User Says Thank You to jay see For This Useful Post:
Mickhead (30th March 2020)
-
29th March 2020, 10:21 PM
#466
Patrol Guru
Originally Posted by
jay see
If you take a plastic piece of the interior trim into Bunnings they have a colour spectrophotometer that will read the colour information from a surface and mix up paint to match it.
You can get a sample pot around 250mls for about $8 from memory, but they will do whatever quantity you need.
-
-
29th March 2020, 11:29 PM
#467
Legendary
Thanks.
But Supercheap and Autobarn both do it in a can just need to provide interior code, pretty sure it's code K.
Sent from my CPH1979 using Tapatalk
12/97 GEE YOU
4.5lt Gas blower. Lots of mods to come.....all in good time.
-
-
30th March 2020, 09:05 AM
#468
Patrol Guru
Originally Posted by
jay see
Thanks.
But Supercheap and Autobarn both do it in a can just need to provide interior code, pretty sure it's code K.
Sent from my CPH1979 using Tapatalk
Oh that's great then, I didn't know they could match interior colours, very cool!
The codes are stamped on the VIN plate on the fire wall
-
-
30th March 2020, 10:13 AM
#469
looking good mate, coming along well. I would have just cut a hole, well a rectangle within the side but not up to the top, you wouldn't block that much ventilation by leaving 10-20mm there.
-
-
30th March 2020, 05:42 PM
#470
Expert
Originally Posted by
Cremulator
Oh that's great then, I didn't know they could match interior colours, very cool!
The codes are stamped on the VIN plate on the fire wall
Tightass method of code K: Bunnings close enough because its not a Lexus E3695842-F1D8-4524-A464-CB7C7105CA38.jpeg8CF2906B-056B-4ABB-87ED-F64C053D489F.jpeg
-