Welcome to the Nissan Patrol forum. To post a question and to see less adds on the forum then you will have to register
first. We are an easy going friendly forum so join in the conversations and feel free to ask any questions.
Become a forum sponsor for only $20 and see no adds with faster page loading times and many extras benefits.
So the Y62 has front hydraulic height adjustment from factory but not rear?
No ir had HBMC Hydraulic Body Motion Control that is basically a Hydraulic sway bar system. The rear springs drop out but the front doesn't have the same range of motion and needs thebsystem to be depressurised to allow the front springs to be removed safely and then depressurised on completion.
The front also needs new Upper Control arms to increase front axle load rating adding 180kgs to the front for the bar and winch
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!! ....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
Originally Posted by Rogue Dung Beetle
Wish it was Nissan though, Toyotas just can't keep up with the Pootrol pace.
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever. WARNING: Towballs used for recoveries can, and do kill people and damage property.
I noticed yesterday that one of my HID driving lights has died. I pulled out the receipt for when I bought them in 2012. I installed them when the car was a week old. 12 years is not too bad. So I took the opportunity and bought a pair of these:
Bought a new 9hp engine for the Mobilco workhorse. The old Kohler 6 1/4 hp crank has slapped the con rod in half again (repaired 20 yrs back).
Should do the job.