Hi there, just wondering, if i take out the shim from the top swivle bearings only and not the bottom ones would that be ok? or do i need to take out top and bottom shims? I don't want to go from to loose to too tight, baby steps?
Hi there, just wondering, if i take out the shim from the top swivle bearings only and not the bottom ones would that be ok? or do i need to take out top and bottom shims? I don't want to go from to loose to too tight, baby steps?
one at a time should be fine mate
Its a Nissan! =====> Its a Keeper!! ....... Got a TD42 in it BONUS!! ....... I'm a lucky bugger! I've got 2 of em!
Check out my Toy --> MudRunnerTD's GQ From the Ground Up
The only good thing about an 80 series is..... the front end?? Wrong!!, the Engine?? Wrong!! the Full Time 4WD system?? Wrong!! Its the NissanPatrol.com.au stubby holder fitted over the transfer lever.
WARNING: Towballs used for recoveries can, and do kill people and damage property.
it’s not a good solution.
if you don’t have the same shims top and bottom, it will cause the axle to not be centred in the end of the diff housing which will contribute to premature axle oil seal failure. there’s factory preload settings for a reason
I see what you're saying, that makes sense.
Last edited by jman69; 13th May 2021 at 03:42 PM.
ok, so today i removed the shims from all swivle bearings. There was one shim at each bearing, now there are none. Went for a test drive and found that the wobble was completely gone. Normally it comes at about 90 kph but today,nothing! Once again i'm a happy little patrol driver.
Last edited by jman69; 12th June 2021 at 06:32 PM.
Yes , i'm all too aware of that. But she'll be ok for a while though. I've put the shims in a safe place for when i eventually change the swivle bearings.